Reinforced shock absorber Sandkat4x4 - Nitrogas - Front - Jeep Cherokee XJ Sport
Manufacture Sandkat4x4
99,00 € // Prix HT : 82,50 €
Reference > SR0020006
Front shock approximately 50 mm longer travel to suit the extra lift
All of boxes of shock contain the necessary bushes, nuts and bolts.
For Jeep Cherokee XJ Sport
All of boxes of shock contain the necessary bushes, nuts and bolts.
For Jeep Cherokee XJ Sport
| Brand | Model |
|---|---|
| JEEP | Cherokee XJ |
Sandkat4x4 MANUFACTURING
Nitrogas shocks designed for optimum off-road performance
FEATURES - Large fluid capacity 35 mm bore with double lip urethane seals, sintered iron piston, 16 mm hard chromed piston rod, double welded eye and pin mounts.
TRAVEL - Approximately 50 mm longer travel to suit the extra lift on the springs.
BUSH MOUNTS - Quality rubber bushes for greater fatigue life and wear resistance.
GAS CHARGED - Nitrogen gas cushion to prevent fluid foaming and improve control and handling.
HYDRAULIC FLUID - Top performance oil resists the most extreme temperatures from -40°C to + 120°C.
FINISH - Tough durable electrostatic paint finish to protect against rust and corrosion.
Mounting: FRONT
Fixation: Pin/Barpin
Compression 337mm
Extension 560mm
Top PIN = 10mm
Bottom BARPIN
Note:
Shock priming
The shock should be “primed” before installation: Hold the shock vertical on the ground (normal installation position) and then push down on the shock to fully compress it and then fully extended it several times.
The first movement or two may feel like the shock isn’t working due to its low nitrogen gas pressure that sometimes seeps into the hydraulic area during extended horizontal storage. If this procedure is not performed prior to installation, noisy operation and loss of performance can occur for a short time.
Never try to open or heat.
Always tighten the shocks when the vehicle is laying on the ground.
Nitrogas shocks designed for optimum off-road performance
FEATURES - Large fluid capacity 35 mm bore with double lip urethane seals, sintered iron piston, 16 mm hard chromed piston rod, double welded eye and pin mounts.
TRAVEL - Approximately 50 mm longer travel to suit the extra lift on the springs.
BUSH MOUNTS - Quality rubber bushes for greater fatigue life and wear resistance.
GAS CHARGED - Nitrogen gas cushion to prevent fluid foaming and improve control and handling.
HYDRAULIC FLUID - Top performance oil resists the most extreme temperatures from -40°C to + 120°C.
FINISH - Tough durable electrostatic paint finish to protect against rust and corrosion.
Mounting: FRONT
Fixation: Pin/Barpin
Compression 337mm
Extension 560mm
Top PIN = 10mm
Bottom BARPIN
Note:
Shock priming
The shock should be “primed” before installation: Hold the shock vertical on the ground (normal installation position) and then push down on the shock to fully compress it and then fully extended it several times.
The first movement or two may feel like the shock isn’t working due to its low nitrogen gas pressure that sometimes seeps into the hydraulic area during extended horizontal storage. If this procedure is not performed prior to installation, noisy operation and loss of performance can occur for a short time.
Never try to open or heat.
Always tighten the shocks when the vehicle is laying on the ground.
- Type : Nitrogas
- Rehausse : 0 > 50mm
- Confort : Reinforced - Offroad
- Véhicules : JEEP:Cherokee XJ
You are a Professional ?
Contact us now
Prices shown are for consumers and include VAT. Companies, Professionals, please contact us to obtain your specific conditions.
Devenir Professionnel
